Parts Description - Makita DLS211ZU Betriebsanleitung

25. When storing the wireless unit, keep it in the
supplied case or a static-free container.
26. Do not insert any devices other than Makita
wireless unit into the slot on the tool.
27. Do not use the tool with the lid of the slot dam-
aged. Water, dust, and dirt come into the slot may
cause malfunction.

PARTS DESCRIPTION

► Fig.2
1 Slide pole
5 Sub base
9 Kerf board
13 Blade guard
17 Adjusting screw (for
lower limit position)
21 Lock lever (for turn base)
► Fig.3
1 Stopper pin (for carriage
elevation)
5 Switch trigger
9 Switch (for laser line)
13 Wireless activation
button
17 0° adjusting bolt (for
bevel angle)
21 Releasing lever (for 48°
bevel angle)
INSTALLATION
Installing the grip
Screw the threaded shaft of the grip into the turn base.
► Fig.4: 1. Grip 2. Turn base
Installing the dust extraction hose
Connect the dust extraction hose to the tool as
illustrated.
Make sure that the elbow and the sleeve fit properly to
the ports of the tool.
► Fig.5: 1. Dust extraction hose 2. Elbow 3. Sleeve
4. Port
To remove the elbow from the port, pull the elbow while
pressing down the lock button.
► Fig.6: 1. Lock button 2. Elbow
2 Stopper pin (for carriage
sliding)
6 Turn base
10 Blade case
14 Knob (for bevel angle)
18 Adjusting bolt (for maxi-
mum cutting capacity)
22 Releasing lever (for turn
base)
2 Hose (for dust
extraction)
6 Lock-off button
10 Battery indicator
14 Wireless activation lamp
18 Pointer (for bevel angle)
- -
28. Do not pull and/or twist the lid of the slot more
than necessary. Restore the lid if it comes off
from the tool.
29. Replace the lid of the slot if it is lost or
damaged.
SAVE THESE INSTRUCTIONS.
3 Vertical vise
7 Pointer (for miter angle)
11 Adjusting screw (for
laser line)
15 Hex wrench
19 Stopper arm
23 Grip (for turn base)
3 Guide fence (upper
fence)
7 Hole for padlock
11 Mode indicator
15 Dust bag
19 45° adjusting bolt (for
bevel angle)
- -
Bench mounting
When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. While lowering the
handle slightly, pull the stopper pin and rotate it 90°.
► Fig.7: 1. Locked position 2. Unlocked position
3. Stopper pin
This tool should be bolted with four bolts to a level and
stable surface using the bolt holes provided in the tool's
base. This will help prevent tipping and possible injury.
► Fig.8: 1. Bolt
WARNING:
on the supporting surface. Movement of the miter
saw on the supporting surface while cutting may
result in loss of control and serious personal injury.
23 ENGLISH
4 Releasing button (for
right side bevel angle)
8 Miter angle scale
12 Range adjustment screw
(for laser line)
16 Sub fence
20 Battery cartridge
-
4 Guide fence (lower
fence)
8 Lid (for wireless unit)
(For DLS211 only)
12 Check button
16 Bevel angle scale
20 Latch lever (for bevel
angle)
-
Ensure that the tool will not move
-
-