Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Code
Description
Communication error. The control board and
E01
computer are not communicating correctly.
Abnormal voltage. Power or voltage situation that can
E02
cause damage to the motor drive circuit.
E03
Speed sensor error.
E05
Over-current protection.
E06
Controller self-check error.
E08
EPROM (Data memory error)
The machine stops and goes into fault status, computer shows "E1", and the alarm beeps
three times. Possible causes: check all the connection points between the console and
controller. Make sure all plugs are well connected. Check all the wires for damage. If this
fails, change the connector wires.
Start and stop fault status. The computer beeps 9 times and shows "E2". Treadmill goes
into the ready mode and restarts. Possible causes: low power or voltage, or faulty
controller. Check all motor wires for correct connection.
Stops and go into fault status. Computer shows "E03". Other areas show blank. After 10
seconds the machine will go into ready mode, and can be restarted.
Possible causes: the computer is not receiving motor speed sensor feedback for more
than 3 seconds: check sensor plug and motor connection wires. Check the controller.
Stops and goes into fault status, computer shows "E05". Other areas show blank. After 10
seconds the machine will go into ready mode, and can be restarted.
Possible causes: system encounters overvoltage and goes to self-preservation. Moving
parts may be blocked. Check and adjust the machine and restart. Check motor or
controller for burning smell. If so, change motor and/or controller. Check whether the
power voltage is too low or not to the standard and retest with the correct voltage.
Computer shows "E06". Possible causes: the controller wires are not connected well,
check and reconnect or change.
Computer shows"E08". Possible causes: the controller wires are not connected well,
check and reconnect or change.
Processing
61
Werbung
