Concept ZN 8017 Bedienungsanleitung Seite 25

EN
EN
OPERATING INSTRUCTIONS
Do not leave the unit unattended if it is connected to the power source.
Remove all the stickers and packaging from the ironing surface before the first use.
clean.
The unit may emit a slight odor during the first use. This smell will vanish after a short time.
Filling with water
1. Unplug the unit from the power source.
2. Set the temperature controller to the minimum.
or boiled water. Don't fill the tank with a liquid other than water. Do not put any
additions in the water. There is a risk of damage to the unit. The capacity of the
4. Close the filling hole cover.
Spraying
a sufficient volume of water in the tank to activate this function.
Steam ironing
1. For steam ironing set the steam volume regulator to the minimum, and the
required position, the steam will start to release, and you may begin ironing.
Steam shock
button – the ironing surface will emit steam. Wait for a couple of seconds before
hanging clothes or curtains. Hold the unit several centimeters from the fabric to
prevent damage to soft materials.
Never iron any clothing on the body!
Ironing
2. Set the temperature controller to the minimum.
3. Insert the plug into the mains outlet.
4. Set the temperature controller to the value that corresponds to the material to
will be illuminated.
Note: Iron fabrics that require a lower temperature first, then those at higher
temperatures. Most fabrics are marked according to international codes – see
the table below.
ZN8007, 8009 ZN8017
and fill the tank with water. Use only distilled
Fig. 1
23 33