Installation - LIVARNO LUX HG05862D Montage-, Bedienungs- Und Sicherheitshinweise

The included mounting material is suitable for ordinary solid concrete or masonry
construction. Check which mounting material is suitable for your chosen mount-
ing surface. If necessary, seek expert advice.

Installation

Make sure you will not be drilling into electrical, gas or water lines inside the wall.
Use a power drill to drill the holes into the brick wall. Always observe all safety in-
structions for the power drill in the manual for the power drill. Death or injury due
to electric shock may otherwise result.
When selecting the mounting location, pay attention to the following:
Make sure that the product illuminates the desired area.
Make sure the motion sensor
has a maximum coverage range of 8 m, with a coverage angle of about 90 °
(depending on the mounting height – a height of 1.8–2.5 m is ideal) (see fig. J).
Make sure the motion sensor
This can influence its functioning.
Remove the nuts
the silicon washers
terminal block
Use the holes in the connection housing
ing screws
11
connection housing with the arrow facing upwards inside the connection hous-
ing .
7
Now drill the fixing holes (Dia. approx. 6 mm, depth approx. 40 mm). Ensure
that you do not damage the electrical supply line (see fig. D).
Now place the wall plugs
Slide the mains connection lead
Fasten the connection housing with the mounting screws
(see fig. E).
Connect the connection cable of the product to the mains connection lead
by means of the terminal block
Also ensure that the colour connection of the wires is correct when connecting
(L = black or brown, N = blue or white).
Now connect the earth wire (green-yellow) to the marked earth terminal
(see fig. F).
Ensure the seal
tached the wall plate
18 GB/IE
covers the desired area. The motion sensor
16
16
visible at the front of the wall plate
5
, and open the connection housing
3
from the connection housing
12
, to mark the drill holes (see fig. C). Ensure that you fasten the
into the drill holes.
10
13
12
is correctly pasted on the connection housing
9
. Now carefully attach the wall plate
6
is not illuminated at night by street lighting.
for easy installation (see fig. B).
7
, which are intended for the mount-
7
through the membrane
(see fig. F).
, flat washers
6 4
. Then take out the
7
.
8
which are included
11
before at-
7
over the con-
6
16
and
13