Getting Started; Installing The Battery/Checking Battery Power - Nikon Nuvis 300 Bedienungsanleitung

Getting started

1
Install the battery.
Slide the battery chamber lid in
the direction of the arrow to
open.
Install one 3V lithium battery
CR2 inside the battery chamber.
Close the battery chamber lid.
•Reset the date and time, when the battery is
replaced and the current data returns to the
initial setting. ( - PP. 28-29)

Installing the battery/Checking battery power

2
Press the power button to
turn the camera on.
•The lens cover automatically opens and
the lens moves out to the W (wide-
angle) position. When film is loaded,
the ISO film speed and the original
number of frames appear for approx.
2 sec. on the LCD panel.
•When the camera is not used for
approx. 3 minutes, the camera turns off
automatically.
3
Check battery power.
•Battery power
appears: Battery is nearly
exhausted. Have a fresh
set ready.
blinks: Battery is exhausted.
Replace the battery.
•If a low battery power indicator "
does not appear, battery power is full.
E
"
9