Viewfinder Indications; Selecting A Print Type - Nikon Nuvis 300 Bedienungsanleitung

Viewfinder indications

E
1Parallax compensation marks
When the shooting distance is approx. 1.2 m (3.9 ft.)
(at 28mm wideangle setting) or approx. 1.5m (4.9 ft.)
(at 80mm telephoto setting), compose the scene
within the parallax compensation marks.
2Autofocus frame mark
Center this mark on the subject.
3Green LED
If the LED lights up: Focusing is complete.
If the LED blinks slowly: Slow shutter speeds are in
use, because the subject is dark. In this case, attach
the camera to a tripod to avoid camera shake.
If the LED blinks quickly: The shutter is locked,
because the camera is too close to the subject. Avoid
shooting subjects closer than approx. 0.7m (2.3 ft.)
14
(at 28mm) or 0.75m (2.5 ft.) (at 80mm).
Available picture area
Areas cut off in the final print differ
depending on the print type (C/H/P).
C-type
(classic)
Aspect ratio = 2 : 3
H-type
(wide-vision)
Aspect ratio = 9 :16
P-type
(panorama)
Aspect ratio = 1 : 3

Selecting a print type

Use the CHP selector to select your
desired print type before shooting.
•You can select any one of three print types
(C, H or P) by switching the CHP selector
at any time while film is loaded. (- P. 4)
Available picture area differs depending on
the print type selected.
•You can also change the type of print when
ordering extra prints at the photo lab.
CAUTION!
To prevent possible injury to your eye,
hold the camera away from your face
when you operate the CHP selector.