Introduction - ergoline Avantgarde 550 Bedienungsanleitung

Dear Ergoline Client,
In selecting an Ergoline sunbed you have acquired a high-performance appliance featuring advanced technology.
Your sunbed has been manufactured at Ergoline with the greatest care and precision, having undergone
numerous quality controls and safety checks. We have done everything to ensure the trouble-free and reliable
operation of your sunbed. However, you also can do a lot to ensure prolonged satisfaction with your Ergoline
sunbed. Please read all of the information carefully. If you follow the tips and information provided in the
operating instructions, your sunbed will give you much joy and pleasure. We will be pleased to help you with
advice if you have any queries.
Yours, Ergoline GmbH
Directives
This sunbed has been manufactured in line with the following directives:
EC Directive on "Electromagnetic compatibility" 89 / 336 / EEC (as amended)
G
Low-voltage Directives 72 / 23 / EEC (as amended)
G
Attention!
We must point out that these sunbeds are intended for the European market only and must not be
exported to the USA or Canada and operated there. No liability will be accepted if this warning is
ignored. It is expressly pointed out that any violation of this ban may subject the exporter and/or
operator to a high risk of liability.
Proper use
This sunbed is designed for tanning one adult person at a time whose skin is suitable for tanning.
Proper use also includes observing all of the directions and regulations described in these operating instructions.
In addition to these operating instructions, also observe generally applicable codes of practice, statutory
regulations and other rules - also in the country of operation - as well as the relevant provisions laid down in
environment law.
Attention must always be paid to the local provisions issued by the employers' liability insurance association or
other supervisory authorities.
Audio frequency blocking filters
The capacitors fitted inside the sunbed to compensate for reactive current may adversely affect the power supply
company's high-frequency control signals superimposed on the mains supply network.
In some cases, depending on location, this may occur in particular if the power supply company uses central
ripple control systems (audio frequency ripple control system - referred to below as AF ripple control system).
The rated control frequency differs from power supply company to power supply company.
Audio frequency blocking filters cannot be factory fitted because it is not known in each individual case whether
an AF ripple control system is in operation and which frequency it is transmitting on.
We refer to the "Technical Conditions of Connection" of the power supply company concerned.
The sunbed operator is responsible for installing any necessary audio frequency blocking filters in the building
wiring system!
If you have any queries, please consult the firm of electricians responsible for installing the sunbeds.

Introduction

3