Safety Notices For Chargers; Charging The Battery Pack; Inserting / Removing The Battery Pack Into / Out Of The Drill / Grinder; Reading Off The Battery Status - Parkside PFBS 10.8 A1 Bedienungs- Und Sicherheitshinweise

Switch the device off and allow it to come to a
standstill before you put it down.
clean, dry and free of oil or grease.

Safety notices for chargers

This appliance can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they have
been given supervision or instruction concerning
use of the appliance in a safe way and under-
stand the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
The charger is only suitable for
indoor use.
Operation
Q
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.

Charging the battery pack

Q
NOTE! A battery pack that has been unused for a
while or never been charged must be charged before
reuse or first use. The battery pack requires about
3–5 cycles before it can reach its full charge. The
charging process takes about 180 minutes.
CAUTION! RISK OF INJURY! Always pull
out the mains plug (mains adapter
you insert the battery pack into or take it out of
the charger.
I nsert the battery pack
cradle . This can only be inserted with the
9
correct polarity.
C onnect the adapter
General safety advice for electrical power tools / Operation
RISK OF INJURY!
Always keep the device
) before
10
into the charging
4
to a mains socket.
10
The red charge level indicator
long as the battery pack is being charged. Once
charging is completed the red charge level in-
dicator will extinguish and the green charge
11
level indicator
11 a
pack is ready for use.
4
CAUTION! Do not charge a battery pack for
a second time in close succession. There is a
danger of overcharging the battery pack.
Inserting / removing the
Q
battery pack into / out of the
drill / grinder
Inserting the battery pack:
S et the ON / OFF switch
I nsert the battery pack
until it engages.
Removing the battery pack:
P ressing the battery pack buttons
sides at the same time allows you to remove
the battery pack
4

Reading off the battery status

Q
The status or residual power is indicated as follows
in the battery-operated LED
ance is switched on:
RED / ORANGE / GREEN = maximum charge / power
RED / ORANGE = medium-level charge / power
RED = weak charge – recharge battery
Inserting or replacing
Q
a tool / collet
P ress the spindle lock
R otate the clamping nut
engages.
L oosen the clamping nut
tion key .
23
I f a tool is already inserted, remove it.
F irst insert the tool you wish to use through the
clamping nut before you insert it into the
6
collet suitable for the tool shaft.
18
will light up as
11
will light up. The battery
to position "0".
5
into the drill / grinder
4
at the
3
.
whenever the appli-
2
and keep it pressed.
8
until the lock
6
with the combina-
6
GB/IE 13