B2.2 Ip Method (Using The Unit Ip Address) - Kavo Scan Exam Gebrauchsanweisung

Imaging plate unit Imaging plate unit
B - 4 B - 4
Reviewed: Anttila Mika Johannes 14.06.11 14:00:39
Approved: Äärynen Teemu 17.06.11 13:12:08
See the PaloDEx Group Oy PDM system to determine the status of this document. Printed out: 29.06.11 12:28:07

B2.2 IP method (using the unit IP address)

B2.2 IP method (using the unit IP address)
If your system does not allow the direct connection If your system does not allow the direct connection
method to be used to connect the PC(s), connection method to be used to connect the PC(s), connection
can be done using an IP address can be done using an IP address
1. Follow steps 1 to 5 from the previous section, 1. Follow steps 1 to 5 from the previous section,
2. PC: From the Settings tab select IP based and 2. PC: From the Settings tab select IP based and
Key the serial number of the unit into the Scan- Key the serial number of the unit into the Scan-
ner serial number fi eld. The serial number of ner serial number fi eld. The serial number of
the unit will appear on the unit display when the the unit will appear on the unit display when the
unit is switched on. It can also be found on the unit is switched on. It can also be found on the
type label on the back of the unit. type label on the back of the unit.
Make sure that the Computer network connec- Make sure that the Computer network connec-
tion that provides the LAN network connection tion that provides the LAN network connection
is selected. is selected.
Direct connection method (uses the unit s/n). Direct connection method (uses the unit s/n).
then select the Enable changing IP address then select the Enable changing IP address
box. box.
B. Installation and setup B. Installation and setup
D506724