Commissioning - EKOM DK50 PLUS/M Benutzerhandbuch

outlet while the latch is released.
Fig. 13: Connecting a compressor installed in a cabinet

13. COMMISSIONING


Check if all fixing elements used during transport have been removed.

Check correct connection of compressed air (see chapter 11).

Check correct connection to the mains (see chapter 12).

Check position of the circuit breaker switch, it must be in position „I". If it is in position „0",
turn the switch (4) to position „I". (Fig. 14).

On DK50-10S/M (8 - 10bar) compressor, switch the switch (5) on the front side of the cabinet
to position „I", the green light indicates the device status in operation. (Fig. 14).

Check, if compressor cabinet (only 8 - 10 bar) is connected with the compressor by a cable
with a connector. (Fig. 13).

Check the connection of the the cabinet pressure gauge hose to the compressor pneumatic
block.
The compressor is not equipped with a backup power supply.
NP-DK50 PLUS, 2V-A-3_02-2020-MD 30
INSTALLATION
02/2020