Parameters; Display Range - Steinbach MINI Bedienungsanleitung

Display:
H
14
- The display 14 shows the current water temperature.
Saving energy
You can take the following measures to reduce the consumption of energy and the
associated costs:
• If you do not use the swimming pool for a few days, (e.g. on the weekend), keep the
current water temperature at about the desired water temperature. The heat pump
cannot heat the water in the swimming pool quickly from one temperature to another.
If there is a large temperature difference between the current water temperature and
the desired water temperature, it can take several days until the desired water
temperature is reached.
• If you do not use the swimming pool for longer than one week, switch off the heat
pump or reduce the set water temperature.
• Do not use the heat pump when the ambient temperature falls below 15 °C.
• Use the control timer (see the chapter on "Operation") instead of leaving the heat
pump in the Operate mode continuously.
• Cover the swimming pool to protect it from heat loss due to the wind.

Parameters

In the Operate mode, pressing the SET button
to be adjusted on the heat pump. The desired parameter can be selected by pressing the Up
or the Down 17 button.
Display:
I
14
- The Display 14 shows the selected parameter (A, B, C, 1-8).
Available parameters:
The heat pump has three temperature sensors that measure the following temperatures:
Parameters
A Current water temperature at the inlet
38
15 16
Set
17
16
Set
18 17
18 allows temperatures to be displayed or settings

Display range

-19 °C - +99 °C
16
-