Configuration Display - Zander Aachen SCB Serie Betriebsanleitung

Safety Time Control Device SCB
3. to 4. Closing of the safety circuit
Through the closing of the safety circuit in combination with a start, the non-delayed out-
puts/contacts are immediately switched on. The blinking Out LED as well as the count-
down shown on the display provide information on the running delay time of the delayed
outputs (depends on the variant).
INFO: The countdown is used only for monitoring. Deviations from the actual delay time
can occur especially in long delay times. This function is available for all variants with a
time range from 0.0 to 99 seconds.
5. Outputs switched
At the end of the delay time, the delayed outputs/contacts switch on and the delay time
currently saved is again shown on the display.
6. Safe state
Through the opening of the safety circuit the outputs/contacts switch off immediately and
the delay time currently saved is shown on the display.

15.3 Configuration display

The information on the configuration currently loaded in the SCB can be read on the dis-
play by pressing the push/rotary button briefly. „Pr" and the current configuration number
are displayed in an alternating manner for 2 seconds.
Y1 Y1
Figure 22: Configuration
H. ZANDER GmbH & Co. KG • Am Gut Wolf 15 • 52070 Aachen • Deutschland • Tel +49 241 9105010
Fax +49 241 91050138 • info@zander-aachen.de • www.zander-aachen.de
26