Configuration Of The Scb; Loading A Configuration - Zander Aachen SCB Serie Betriebsanleitung

Safety Time Control Device

13. Configuration of the SCB

The SCB is delivered with the default configuration "Pr00". With this configuration, the
device evaluates the safety circuit and the reset circuit according to the configuration
table. However, no delay time is executed. A parameterization of the delay time is therefo-
re not possible.
Carry out the following steps when commissioning the device for the first time.
Table 1 explains the symbols used for this purpose.
Symbol

13.1 Loading a configuration

Determine the desired configuration number using the configuration table shown in Chap-
ter 16. By entering a PUK (Parametrization Unblocking Key) you reach the configuration
selection (PUK for loading a configuration: 6 - 1).
To do this, switch on the supply voltage while pressing the push/rotory button at the same
time. A running light as well as the following display "Pu" informs about the menu item
PUK (see Figure 18).
H. ZANDER GmbH & Co. KG • Am Gut Wolf 15 • 52070 Aachen • Deutschland • Tel +49 241 9105010
Fax +49 241 91050138 • info@zander-aachen.de • www.zander-aachen.de
Description
Press the push/rotary button for minimum 2 seconds.
Enter (2s)
Press push/rotary button briefly
Enter
Turn push/rotary button
2 s Wait for 2 seconds
Table 1: Symbol explanations
Power-
On
+
Y1
Figure 18: Display during entry into menu item PUK
7 s
Y1 Y1
19