Christopeit EM4 - 1410 Montageanleitung Und Bedienungsanleitung Seite 18

Step 4:
Attach the handlebar (9) at handlebar support (70).
1. Guide the preassembled handlebar unit (9) through the upper part of the
handlebar post (70) and push the pulse cable (8) through the holes at
handlebar support into top position and close the bracket of handlebar
holder.
2. Screw the handlebar (9) in desired position at the handlebar post (70)
with distance tube (12) and handlebar screw (11).
Step 5:
Attach the saddle (13) at saddle slide (14).
1. Push the saddle (13) with saddle bracket into the saddle slide (14) and
tight it up in desired position.
2. Place the saddle slide (14) into the holder of saddle post (21), set it at
the desired position and screw it onto the saddle support (21) by hand
grip nut (20) and washer (19) and fixing bracket (18).
Step 6:
Attach the saddle support (21) at main frame (65).
1. Place the saddle support (21) into the matching locator in the main
frame (65), set it at the desired position and lock it by inserting the bolt
with the quick release (23) in place and doing it up tight. (The setting of
the saddle support can adjust easily as desired later through turning
and pulling the quick release (23).) Furthermore, you must ensure when
setting this desired position that the seat pillar is not pulled out of the
main frame further than the highest setting position, which is marked.
18