Trimming Manually; Flight Instructions For Beginners; Selecting A Suitable Location; Take-Off - Reely TWINS Bedienungsanleitung

If the model drifts upwards: Press the trim button for the elevator (downwards) (R5) repeatedly until the model flies
in a straight line.
If the model drifts downwards: Press the trim button for the elevator (upwards) (R6) repeatedly until the model flies
in a straight line.

13.3 Trimming manually

T2
The elevator trim can be adjusted manually.
If the elevator trim on the remote control is not sufficient, there are two ways to achieve a better trim:
• Bend the elevator wire slightly
• Place the wire in a different slot
Reset the trim settings for the elevator on the remote control.

14. Flight instructions for beginners

14.1 Selecting a suitable location

For the first few flight attempts we recommend flying the model in a large field, a sports field, a model airfield or a
large warehouse/sports hall. If you are flying the model outdoors for the first time, wait for a day with little or no wind.

14.2 Take-off

• When flying the model outdoors, the model must be launched and landed against the wind. When flying the model
indoors, launch the model from a corner of the room rather than the centre. This ensures that you have enough
space for flying in a large circle.
• To ensure that you can identify the location of the model, you should stand behind and to the side of your assistant
and look directly at the flight path.
• In preparation for take-off, your assistant should hold the model with their thumb and index finger on the bottom
of the fuselage under the wings. Slowly apply the throttle and let the motor run at full power. Your assistant should
then release the model forwards in a straight line with a gentle push.
• The model should ascend at a flat angle. You may need to reduce the motor speed. Try to adjust the controls as
little as possible. Only adjust the controls if the model changes its altitude, flies in a curve, ascends too rapidly or
if the nose points downwards.
• When fine tuning the altitude and correcting the direction of flight, it is only necessary to move the remote control
joysticks briefly and by small amounts.
• Once the desired altitude has been reached, reduce the motor power or switch off the motor. Start the first curve.
46
.
T2-A
.
T2-B