Using The Single Point Calibration Feature - OHAUS Guardian 7000 Serie Installations-, Betriebs- Und Wartungsanweisungen

EN-32
27. Briefly press the left knob (C) to return to the main
operating screen.
a) Notice the Bluetooth icon (W) is illuminated to
show that the SmartLink™ feature is enabled.
When the SmartLink™ feature is enabled, the
b)
heater cannot turn on without Bluetooth
connectivity.
If the left knob (C) is pressed to turn the
heater on, the Bluetooth icon will blink,
indicating that there is no Bluetooth
connection with the OHAUS SmartLink™ app.
Once the SmartLink™ feature is turned on and the OHAUS SmartLink™ app is connected to the unit via
1.
®
Bluetooth , the Bluetooth icon (W) will be illuminated on the main operating screen.
2. If the heater is running and the unit loses the Bluetooth connection with the paired phone:
a) The unit will beep 5 times.
b) The Bluetooth icon (W) will begin blinking.
To reset the SmartLink™ "Time Out" timer:
A.
a) Reestablish Bluetooth connection with the unit.
If the Bluetooth connection is not reestablished for the time set in the "TOUT" setting:
3.
a) The heater will shut off.
b) The unit will beep 5 times.
The Bluetooth icon (W) will continue blinking to indicate that the heater was turned off by the SmartLink™
c)
feature.
d) If the unit is stirring, the stirrer will remain on and the timer (T) will continue to count.
e) If the unit is heating only, the timer (T) will reset to 00:00 or the previous countdown timer setting.
B. To restart the heater:
a) Reestablish Bluetooth connection.
b) Then press and hold the left knob (C) until the heater indicator (N) illuminates.

2.14 Using the Single Point Calibration Feature

Single Point Calibration (SPC) improves the accuracy of the heater at user-selected temperature points. Up to 5
points (Plate) and 5 points (Probe) can be stored at once.
1. To control the Single Point Calibration feature, the
unit must first be in the top level of the settings
menu.
2. Rotate the left knob (C) to scroll to the 'CAL'
feature.
3. Briefly press the left knob (C) to enter the
Calibration settings menu.
Guardian 7000 Series