Loading A User Program - OHAUS Guardian 7000 Serie Installations-, Betriebs- Und Wartungsanweisungen

EN-22

2.10 Loading a User Program

1. Once the program is complete, save it to a USB
storage device named "PROG.txt".
2. Insert the USB storage device into the USB Port
(E) on the rear panel of the unit.
3. To control the User Programs feature, the unit
must first be in the top level of the settings menu.
4. Rotate the left knob (C) to scroll to the 'PROG'
settings.
5. Briefly press the left knob (C) to enter the User
Programs settings menu.
6. Rotate the left knob (C) to scroll to the LOAD icon.
7. Briefly press the left knob (C) to load the program
onto the unit.
a) The program will be loaded into the lowest
empty program slot. These slots are named
P1, P2, P3, P4, & P5.
b) The unit will beep once and display the
program slot name that the program was
loaded into.
c) If there is not an empty program slot for the
unit to load the program to, the unit will
display "ERR" and the program will not be
loaded.
d) Once the program is loaded, it is safe to
remove the USB storage device from the
unit.
8. To clear a program, rotate the left knob (C) to the
"CLR" setting.
9. Briefly press the left knob (C) to enter the CLR
settings.
Guardian 7000 Series