Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Reason
Memory set
Use USR5.
Hold down the UR-80's MEMORY button and press the Track Status button USR5.
Software
Reason version 2.0 or later is required.
MIDI port settings
1.
From the Edit menu, choose Preferences.
2.
In Page, choose "Advanced MIDI".
3.
Make the following MIDI port settings.
Any one of Bus A–D
Remote Control
MIDI Clock Sync
You can use UR-80 Editor to change the MIDI port used for MIDI Clock Sync. To do this, change
the output port for the Sync Start and Sync Stop messages assigned to [SHIFT]+STOP and
[SHIFT]+PLAY.
For details on how to make this change, refer to UR-80 Editor (p. 73).
Settings for reason transport and MIDI IN DEVICE
If you want to use the UR-80 to control Reason's modules or transport, you must make the
following settings for each song.
1.
In the Options menu, choose Edit MIDI Remote Mapping to enable it.
2.
Click the Stop button of reason transport.
The MIDI Remote dialog box will appear.
3.
Check "Learn from MIDI Input".
4.
Press the UR-80's STOP button, and click [OK] in the MIDI Remote dialog box.
5.
Make the following assignments in the same way.
UR-80 controller
6.
In the Options menu, choose Edit MIDI Remote Mapping to disable it.
7.
In the Options menu, make sure that Enable MIDI Remote Mapping is checked. If it is not checked,
select the menu item to enable it.
8.
Click the MIDI IN DEVICE module CHANNEL 16 button, and select the Mixer device that you want
to control.
EDIROL UR-80 1
EDIROL UR-80 2
EDIROL UR-80 1
reason transport
Stop
Play
Rewind
Forward
Record
Loop ON/Off
Controlling your software
51
Werbung
Inhaltsverzeichnis
