Logic; Settings In Logic - Roland Edirol UR-80 Bedienungsanleitung

Logic

Memory set
Use URS3.
Hold down the UR-80's MEMORY button and press the track status button USR3.
Software
Logic 5 version 5.5 or later is required.
* Each time you start up Logic, you must select the memory set for Logic on the UR-80 itself.

Settings in Logic

1.
Start up Logic.
2.
When Logic has started up, select the memory set for Logic on the UR-80.
* Even if the memory set for Logic is already selected on the UR-80 itself, you must select the Logic memory
set each time you start up Logic.
fig.logic-setup
3.
If the Setup window appears, click the Logic Control
icon located in the right of the window.
* If the Setup window does not appear, proceed to step 7.
4.
In the Logic Control area in the left side of the Setup
window, make the following Out Port settings. (Even if
the display already indicates the settings shown below,
make the settings again.)
Out Port: EDIROL UR-80 (for Windows or Mac OS X)
Out Port: UR-80 1 (for Mac OS 9)
5.
Close the Setup dialog box.
6.
Once again select the Logic memory set (USR3) on the UR-80.
7.
If a dialog box like the following appears, click [Cancel].
Windows
fig.logic-win fig.logic-mac
Macintosh
Controlling your software
43