System-Related Settings; Restoring The Factory Settings (Factory Reset); Switching The Driver Mode - Roland Edirol UR-80 Bedienungsanleitung

System-related settings

Restoring the factory settings (Factory Reset)

1.
While holding down the STOP button and MEMORY button, turn on the power. The REC button
LED will blink.
2.
Press the REC button to initialize the settings.
* If you perform any operation other than pressing the REC button, the UR-80 will return to normal operation
without being initialized.
Initialized setting
User memory sets
V-LINK initialization message
MIDI Timing Clock on/off switch
Default Tempo
MIDI Timing Clock output port
HQ/GM2 output port
V-LINK message output port
Driver mode
REC SOURCE
INOPUT MONITOR

Switching the Driver Mode

You can switch the mode (type) of driver used for USB connection.
With the factory settings, Original Driver Mode is selected. Normally, you should use Original
Driver Mode.
Original Driver Mode
Standard Driver Mode
* If the UR-80's sampling frequency is set to 96 kHz REC or 96 kHz PLAY, it cannot be started up in Standard
Driver Mode.
Checking the Driver Mode
If Original Driver Mode is selected, the HQ/GM2 button LED will light for approximately
two-seconds when you turn on the power.
If Standard Driver Mode is selected, the V-LINK button LED will light for approximately
two-seconds when you turn on the power.
Mac OS 9 series users
If you are using a Sound Manager-compatible application, use the UR-80 in Standard Driver Mode.
If you start up in Standard Driver Mode, a message like the following will appear.
"Cannot use the driver required by USB device "UR-80". Search for a driver on the Internet?"
If this message appears, click [Cancel]. You will be able to use only the UR-80's audio functionality.
* You cannot use UR-80 Editor in Standard Driver Mode.
348
Initial value
—
—
OFF
120
1
1
1
Original driver mode
ANALOG
OFF
Turn on the power of the UR-80 while holding down the HQ/GM2 button
Turn on the power of the UR-80 while holding down the V-LINK button