Master Control Section - Roland Edirol UR-80 Bedienungsanleitung

Master Control section

The Master Control section is where you can execute commands and control the transport on your
sequencer software. Here you can also make settings for the UR-80's audio interface.
* The content that is controlled will depend on the software you are using.
fig.master-ctrl
8
10.
Function buttons....................................................................................................
You can assign MIDI messages to these six buttons. Since you can also assign messages for when
the SHIFT button is being held down, a total of 12 MIDI messages can be assigned to these buttons.
You will typically use the function buttons to execute various commands on your sequencer
software.
11.
Transport buttons ..................................................................................................
You can assign MIDI messages to these six buttons. Since you can also assign messages for when
the SHIFT button is being held down, a total of 12 MIDI messages can be assigned to these buttons.
You can also assign MIDI messages to control the two LEDs located above the
transport buttons.
These buttons are typically used to control the transport of your sequencer software.
8.Cursor buttons .....................
You can assign MIDI messages to these four
buttons. Since you can also assign messages for
when the SHIFT button is being held down, a
total of eight MIDI messages can be assigned to
these four buttons.
Use the cursor buttons to switch the track that is
selected in your sequencer software or to move
the focus point.
9
9.TIME dial................................
You can assign one MIDI message to this dial.
Use the TIME dial to move the song location
10
within your sequencer software.
12
If you hold down the SHIFT button and turn the
TIME dial, the dial will adjust the input monitor
level. For details on input monitoring, refer to
p. 22.
11
Names of Things and What They Do
Assignable
Assignable
Assignable
Assignable
and
21