Before use
Charging the battery pack (see fig . A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket.
The control LED
♦
The green LED
indicates that the charging
process is complete and the battery pack
ready.
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash, this means that the battery pack
defective.
♦
Push the battery pack
♦
Switch off the charger
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
PSSA 20-Li A1
to the high-speed
(see fig. A).
lights up red.
flashes, this means
has overheated and
both
into the appliance.
for at least 15 minutes
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Allow the battery pack
the appliance.
Removing the battery pack:
♦
Press the release button
battery pack
Checking the battery charge level
♦
Press the battery charge level button
the status of the battery (see also main diagram).
The status will be shown on the battery display
LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting/changing the saw blade
WARNING!
►
Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
is
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury.
♦
Turn the quick-release chuck
stop and hold it in this position.
♦
Push the required saw blade
quick-release chuck
is
CAUTION!
►
The teeth of the saw blade
downwards!
to click into place in
and remove the
.
as far as the
into the
as far as the stop.
must point
GB │ IE
│
to check
21
■