EuroLite DMX Move BIGFOOT Bedienungsanleitung Seite 23

No. No. No. No. Element Element Element Element
1 Upper display
2 ENTER button
3 MENU/ESC button
4 DEL button
5 SWAP button
6 CHANNELS encoders
7 PAGE/CLEAR button
8 REC button
9 FIXTURE buttons
10 CHASE/MOVEMENTS
buttons
11 CHASE/MOVEMENTS button
12 Handle
13 Lower display
14 Blank buttons
15 RUN MODE button
16 GO button
17/18 UP and DOWN button
19 BLACKOUT button
20 NORMAL button
21 MUSIC button
22 TAP button
23 FADE TIME pedal
24 MASTER/DIMMER pedal
Function Function Function Function
Blue backlit; indicates the operating mode, DMX values and system
settings.
To confirm adjustments in program mode and in the system settings.
• Long actuation: To call and exit the system settings.
• Short actuation: To abort a setting procedure and jumping back to a
higher menu level.
• For inserting a scene into a chase.
• Program mode: For deleting scenes or chases keep this button pressed
and select the memory bank to be deleted with the number buttons 1-
15.
• System settings: To zero unused control channels.
• FX mode: For switching between the parameters.
• System settings: For switching between options.
For adjusting the DMX values of the connected light effect units. The
current DMX value is indicated in the display. The encoders are split into 2
pages so that 2 x 8 DMX channels can be controlled per fixture.
• To switch the encoders between the 2 fixture pages. The LEDs above
the button indicate which page is selected.
• Keep this button pressed for 3 seconds to set all adjustments made
through the encoders and encoder wheels to zero.
• Long actuation: To call and exit the program mode.
• Short actuation: To store settings in the program mode.
• To select and deselect up to 12 devices. The adjacent LEDs light to
indicate which devices are selected.
• System settings: For naming the chases.
These buttons have a dual occupancy, which can be switched with the
CHASE/MOVEMENTS button.
• Chase mode: To store and activate chases.
• Movement mode: To activate and deactivate effects.
• System settings: For naming the chases.
To switch the number buttons 1-15 between chase and movement mode.
The adjacent LEDs light to indicate which mode is selected.
Red backlit; indicates the options in the program mode and system
settings.
These buttons belong to the lower display. The respective function is
indicated in the display.
In automatic mode, this button alters the play of scenes. Short actuation
makes the steps play faster, long actuation makes them play slower.
To start the preselected chase.
To preselect the next chase.
Turns off all fixtures or sets all control channels to the value zero
( system settings).
To return to normal speed after actuating the RUN MODE button.
To activate sound-control mode. The scenes will be synchronized with
music pulses at the AUDIO jack or, if the jack is not connected, via the
internal microphone.
Press this button twice to adjust the running speed in automatic mode.
To adjust a fade time between for the individual steps of the chase.
To adjust the brightness of the fixtures connected. All values of the control
channels for which an influence by the pedal has been allowed ( system
settings) can be controlled simultaneously.
23 • EN