Ryobi RM480e Übersetzung Der Originalanleitung Seite 43

The side discharge chute or opening
is plugged.
The grass is wet.
Poor grass
discharge.
The mowing speed is too fast.
The grass is too high.
The cutting height is set too low.
The motor stops
while cutting.
The battery charge is low.
The battery charge is low.
The side discharge interlock switch
is not pressed by the side discharge
chute.
The blades do not
rotate. The blade engage knob is down.
The operator is not fully seated.
There is build-up of debris under
mower.
The reverse mode option is off.
The blades do not
rotate while moving
in reverse. The blade engage knob is down.
The product won't The battery charge is low.
reach full speed.
The blades The safety interlock system is not
continue to turn functioning correctly.
after the operator
leaves the seat
without engaging
the parking brake.
The headlights are off.
The headlights are
not working.
The headlights are damaged.
The battery cells are bad.
The battery will not
charge.
The cable connections are poor.
Clean the side discharge chute and opening.
Allow grass to dry before mowing.
Mow at a slower speed.
Mow once at a high cutting height, then mow again at
the desired height.
Raise the cutting height.
Charge the battery.
Charge the battery.
Push down the side discharge chute, and make sure that
it fully presses the side discharge interlock switch.
Pull up the blade engage knob.
Fully sit down on the seat.
Clean the underside of the mower deck.
Press the reverse mode button to activate reverse mode.
Pull up the blade engage knob.
Charge the battery.
Ensure that the safety interlock system seat plug is fully
connected. If the blades still won't stop, have the product
serviced by an authorised service centre only.
Press the headlight button to turn on the headlights.
Replace the headlights.
Replace the battery.
Check and clean all the battery connections.
EN
FR
DE
DA
SV
FI
NO
English | 41