Storing The Product - Ryobi RM480e Übersetzung Der Originalanleitung

Bolt
Lock washer
Flat washer
Red (+)
Thermistor terminal
WARNING
Under abusive conditions, liquid may be
ejected from the batteries; avoid contact.
If contact accidentally occurs, fl ush with
water. If liquid comes in contact with eyes,
additionally seek medical help. Liquid
ejected from the battery may cause irritation
or burns.
11. Lift the battery securing bracket off the
batteries, and set aside.
12. Remove and set aside the battery covers
for the battery or batteries being replaced.
13. Disconnect the battery or batteries that
need to be replaced.
Disconnect the negative (black) cable
first, then the positive (red) cable. Be
careful not to short across the terminals.
NOTE: When disconnecting the rear
cables, take note of the position of the
battery thermistor terminal on the positive
post. Make sure to reinstall the terminal in
the same location.
14. Replace the battery or batteries as
needed and reinstall cables. Connect the
positive (red) cable first, then the negative
(black) cable, being careful not to short
across the terminals.
15. Reinstall the battery covers and the
battery securing bracket.
16. Push the battery tray back inside the
mower just enough to allow you to
reconnect the battery quick-connect plug.
NOTE: To gain enough leverage to
reconnect, it is often easier to connect
from the battery compartment area rather
than the area under the seat.
17. Once the batteries are reconnected to the
mower, push the battery tray fully back
inside the mower.
18. Reinstall the flange bolts and flange nuts
to secure outside edge of battery tray.
Tighten securely.
19. Reinstall the hex head bolt to secure
battery tray in place. Tighten securely.
20. Connect the battery thermistor.
21. Replace the battery compartment cover,
and reinstall hardware to secure.
NOTE: Make sure that the tabs on the
battery compartment cover are seated
in the slots on the mower top and side
panels before tightening the screws.
Fig 36
22. Reinstall wiring cover, and push down
until it latches securely in place, then
lower the seat.
NOTE: Always ensure that the safety
interlock cable connection is still fully
seated when replacing the wiring cover.
NOTE: Always abide by the safety warnings
provided with
old battery according to local and state
regulations.

STORING THE PRODUCT

The following steps should be taken before
storing the product:
■ Park the mower on a level surface, and
engage the parking brake.
■ Remove any build-up of grass and leaves
on or around the motor cover. Wipe the
product clean with a dry cloth. Do not use
water to clean the product.
■ Plug the product up to charge for the entire
time of storage.
NOTE: If it is not possible to leave the
mower charger connected during storage,
charge the batteries at least once a month
during storage. The batteries charge best
at temperatures from 0 °C to 40 °C.
■ Store the product in a clean, dry place that
is inaccessible to children. Do not store
near any appliance that operates with
flame such as a gas water heater, clothes
the battery. Dispose
English |
EN
FR
DE
DA
SV
FI
NO
of
37