Installing The Seat; Connecting The Battery - Ryobi RM480e Übersetzung Der Originalanleitung

WARNING
Strictly adhere to all torque wrench
tightening specifi cations. Failure to do so
could cause serious personal injury.
WARNING
Do not attempt to modify the product or
create accessories not recommended for
use with the product. Any such alteration or
modifi cation is a misuse and could result in
a hazardous condition leading to possible
serious personal injury.
WARNING
To prevent accidental starting that could
cause serious personal injury, always
remove the start key from the product when
assembling the parts.

CONNECTING THE BATTERY

See fig. 2
When shipped from the factory, the product's
batteries are disconnected.
To connect:
1. Press the tabs on the wiring cover, and lift
the cover to remove.
2. Connect the two ends of the battery
quick-connect plug together.
NOTE: Before reinstalling the wiring cover,
install the seat as described in the next
section.
Wiring Cover
Battery quick-connect plug

INSTALLING THE SEAT

See fig. 3
1.
2.
3.
4.
5.
Tab
Fig 2
Remove the bolts and flange nuts from
seat mounting brackets.
Place the seat assembly over the
mounting brackets, aligning the holes as
shown.
Reinstall and securely tighten the bolts
and flange nuts.
Route the seat safety interlock cable
through hole in the wiring cover, then
connect to the plug on the mower.
Reinstall wiring cover, and ensure that it
is securely seated.
Wiring cover
Plug
Shoulder
Flange nuts
bolt
Mounting
bracket
EN
FR
DE
DA
SV
FI
NO
Seat assembly
Safety interlock
cable
Mounting
bracket
Fig 3
English | 15