Ryobi RM480e Übersetzung Der Originalanleitung Seite 36

appearance of the cut, and proper infl ation of
the tyres may be all that is needed to resolve
uneven cutting issues.
NOTE: Always check side-to-side alignment
and adjust as needed before measuring and
adjusting front to back.
Before beginning:
1. Make sure that the direction control switch
is in the neutral (N) position and the blade
engage knob is down.
2. Turn off the product, engage the parking
brake, and remove the start key.
3. Set the cutting deck to the maximum
height.
To make side-to-side adjustment:
1. Position the blades so that the ends point
toward the sides of the mower.
2. On the outside edge of each blade,
measure the distance from the bottom
edge of the side of the blade to the
ground. If the distance between the two
sides is greater than 0.32 cm (1/8 in.) , a
side-to-side adjustment is necessary.
3. On the side you wish to adjust, loosen the
jam nuts as shown.
4. Turn the adjustment nuts clockwise to
raise or counterclockwise to lower the
side of the cutting deck. Each full turn of
the adjustment nut will change the deck
height approximately 0.48 cm (3/16 in.).
NOTE: If raising the side, you will need
to turn the top adjustment nut first. If
lowering, turn the bottom nut first.
5. Measure the distance between the blade
and ground again. Continue to adjust and
measure until the difference between the
distance on each side is 0.32 cm (1/8 in.)
or less.
6. Proceed to front-to-back adjustment or
retighten jam nuts to secure.
To make front-to-back adjustment:
NOTE: Always level the deck side to side
before making a front to back adjustment.
1. Position the blade nearest the side
discharge chute so that the ends now
point toward the front and back of the
mower.
2. Measure the distance from the tip of the
blade to the ground. For best results, the
front tip of the blade should be from 0.32
cm. to 0.95 cm. (1/8 in. to 3/8 in.) lower
than the rear tip.
34 | English
3. If front-to-back adjustment is needed,
turn the adjustment nuts clockwise to
raise or counterclockwise to lower the
back of the cutting deck. Each full turn of
the adjustment nut will change the deck
height approximately 0.32 cm. (1/8 in.).
NOTE: Make sure to turn the adjustment
nuts on both sides equally to prevent
throwing the side-to-side measurement
off again.
4. Measure the distance between the blade
and ground again to verify that the front
tip is 0.32 cm. to 0.95 cm. (1/8 in. to 3/8
in.) lower than the rear tip. If not, continue
to adjust and measure until they are.
5. Without moving the adjustment nuts,
retighten the jam nuts to secure the
adjustment nuts in place.
Bottom edge
Jam nut
Adjustment
nuts
Jam nut
Blade
Fig 29
Fig 30