Charging The Product - Ryobi RM480e Übersetzung Der Originalanleitung

INSTALLING THE BUMPER
See fig. 6
1. Remove the flange nuts and hex head
bolts that secure the bumper cover to the
mower frame.
2. Install the bumper into the openings at the
front of the mower frame as shown.
3. Align the holes in the bumper, the mower
frame, and the bumper cover. Reinstall
and securely tighten the hex shoulder
bolts and flange nuts.
Hex head bolts
Flange nut
Bumper cover

CHARGING THE PRODUCT

See fig. 7 - 8
Mower batteries must be charged for 24 hrs.
before fi rst use. To verify that the mower
batteries are fully charged, check the battery
level indicator.
For best results:
■ Do not charge in an area of extreme
heat or cold. The batteries charge best at
temperatures from 0 °C to 40 °C.
■ Never charge a frozen battery.
■ Mount or place the charger in an area with
adequate ventilation, without covering the
cooling fins.
■ Make sure that both the charger and
mower connections are clean and free of
dirt or debris.
To charge:
1. Insert the charger plug into the charging
port on the mower, making sure that it is
properly connected.
2. Connect the charger to a power supply
using normal household current of of 220-
240 VAC, 50 / 60 Hz. The batteries should
automatically begin to charge.
Flange nut
Fig 6
Bumper
3. When you are ready to mow, disconnect
the charger from the power supply, then
disconnect the charger from the mower.
NOTE: The charger is equipped with a plug
featuring a grounding pin and must be plugged
into a matching outlet that has been properly
installed and grounded in accordance with
all local codes and ordinances. Do not use
adaptors or modify the plug provided. If it
does not fi t the outlet, have the proper outlet
installed by a qualifi ed electrician. The metal
enclosure of the charger is not earthed.
When powered, the LED indicator on the
charger illuminates to indicate the charger's
status. Refer to the following chart to
determine the meaning of the LED's display.
WARNING
Always turn the power switch to the OFF
position and remove the start key when
charging the product and when the product
is not in use.
Charger LED
indicator
Charging port
Charger plug
Fig 7
Fig 8
English | 17
EN
FR
DE
DA
SV
FI
NO