Replacing The Batteries - Ryobi RM480e Übersetzung Der Originalanleitung

REPLACING THE BATTERIES

See fig. 31 - 36
NOTE: Use only RYOBI ride-on mower lead-
acid batteries, part number 5131042607.
The mower operates on four 12-volt batteries
connected in series. If replacing one or more
of the batteries, always replace them using
batteries of the same type with equal voltage
and capacity.
WARNING
Use only original lead-acid batteries when
replacing.
Never mix different makes and sizes
of batteries in the series. Doing so will
eventually cause damage to the batteries
and may also damage the mower.
WARNING
Do not open or damage the batteries.
Released electrolyte is corrosive and may
cause damage to the eyes or skin. It may be
toxic if swallowed.
Do not incinerate the battery. The batteries
could explode. Check with local codes for
possible special disposal instructions.
When batteries are not in use, keep it away
from other metal objects like, paper clips,
coins, keys, nails, screws, or other small
metal objects, that can make a connection
from one terminal to another. Shorting the
battery pack terminals together may cause
sparks, burns, fi re or explosion.
Exercise care in handling batteries in order
not to short the battery with conducting
materials such as rings, bracelets, and keys.
The battery or conductor may overheat and
cause burns.
1. Stop the product on a level surface, and
engage the parking brake.
2. Turn off the product, and remove the start
key.
3. Tip over the mower seat.
4. Push the two tabs on each side of the
cable cover, lift up the cover, and turn it
to one side.
5. Remove and set aside the hex head bolt
that secures the battery tray in place.
6. Disconnect the battery quick-connect
plug. This plug connects the batteries to
the mower.
7. Remove the four screws that secure the
battery compartment cover in place.
8. Disconnect the thermistor plug. The plug
connects the batteries to the charging
port.
9. Remove the two flange nuts and flange
bolts that secure the front of the battery
tray in place.
10. Pull out the battery tray, resting the end
outside the mower on a stable surface
that can support a minimum weight of
136.1 kg. (300 lb.).
Seat
Safety interlock
cable
Wiring cover
Hex head bolt
Battery quick-
connect plug
EN
FR
DE
DA
SV
FI
NO
Tab
Tab
Fig 31
English | 35