Adjusting The Seat - Ryobi RM480e Übersetzung Der Originalanleitung

WARNING
Never leave the product unattended when
the motor is running. Verify that the parking
brake is engaged and the key has been
removed. Failure to engage the parking
brake could cause the product to move, and
leaving the key could allow unauthorised
use that could result in serious personal
injury.
Direction control
switch
Parking brake
Brake pedal

ADJUSTING THE SEAT

See fig. 14
Adjust the seat position to ensure that the
user is able to make fi rm contact with the
accelerator and brake pedals before operating
the product.
To move the seat:
1. Sit down on the seat, and lift the seat
adjustment lever.
2. While holding the lever, slide the seat to
the preferred position.
3. Release the lever, and make sure that the
seat is locked in position before operating
the product.
WARNING
Ensure that the seat is locked into place
before operating the mower. A seat that is
not secure can cause the operator to shift
and lose control of the mower and result in
possible death or serious personal injury.
SETTING THE CUTTING DECK HEIGHT
See fig. 15
Before using the product, raise the deck
height to the cutting position best suited for
your lawn.
NOTE: To prevent scalping the lawn when
encountering high spots, the cutting deck
wheels should be positioned approximately
1.27 cm (1/2 in.) off the ground when the
Fig 13 mower is at the desired cutting height. When
shipped, the cutting deck wheels are set to
the 3.81 cm (1.5 in.) position. Depending on
your desired cutting height, you may need to
change the position of the cutting deck wheels.
To do so, refer to the "Adjusting Cutting Deck
Wheels" section in this manual.
To adjust the cutting deck height:
1. Stop the product and disengage the
blades.
2. Turn the start key to the OFF position and
engage the parking brake.
3. To raise the cutting deck, grasp the deck
height adjustment lever, push left to
disengage from slot, move toward the
back of the mower, then push right into
slot to secure.
4. To lower the cutting deck, grasp the
deck height adjustment lever, push left
to disengage from slot, move toward the
front of the mower, then push right into
slot to secure.
Seat adjustment lever
English |
EN
FR
DE
DA
SV
FI
NO
Fig 14
23