Ryobi RM480e Übersetzung Der Originalanleitung Seite 34

Blade half circle
post
Blade half
circle hole
Spacer
Blade nut
32 | English
Shaft
Blade circle
post
Blade
circle
hole
Center
blade hole
Blade
Blade
insulator
Fig 25
Straight sides
aligned
Fig 26
TYRE MAINTENANCE
The product is equipped with tubeless tyres
with the following dimensions:
■ Front tyres: 38.1x15.2x15.2 cm
■ Rear tyres: 40.6x16.5x20.3 cm
Tyre air pressure
Check the air pressure in all tyres before use.
Improper air pressure will affect handling,
steering response, traction, tyre life, level
cutting, and operator comfort. Be sure tyres
are infl ated to the recommended pressure
(1.6 bar).
NOTE: Tyre pressure
measured or adjusted when tyres are cold.
WARNING
Check the tyre pressure carefully while
infl ating. Too much air in the tyre could
cause the tyre to burst, causing serious
personal injury.
WARNING
Maintaining correct air pressure in the
tyres is very important. Too little pressure
could allow the tyre to rotate off the wheel
rim. Too much pressure could cause the
tyre to burst. Failure to maintain correct air
pressure in the tyres could cause problems
with mower operation and stability, causing
serious personal injury.
TYRE REPAIR
If a leak or fl at tyre occurs due to a puncture,
the tyre may be repaired using a plug-type
patch. If the damage is from a cut, or if the
puncture cannot be repaired using a plug,
replace the tyre.
REPLACING TYRES
When tyres are worn, the traction of the mower
decreases, which increases the chance of
having an accident. Replace the tyres when the
depth on the tread is 4 mm or less, or any time
there is damage to the tyre. Always use original
replacement tyres. Using improper tyres on
the product could cause loss of control, which
could cause serious personal injury.
Have the tyres replaced only by an authorised
service centre.
should only be