Adjusting The Brakes - Ryobi RM480e Übersetzung Der Originalanleitung

ADJUSTING THE BRAKES

See fig. 27
Being able to stop the mower properly is
critical to mowing safety. If the mower travels
farther before stopping when you step on the
brake pedal, the brakes may need adjusting.
To test:
1. Stop the product on a level surface and
engage the parking brake.
2. Set the direction control switch in neutral
(N) position.
3. Stand behind the mower and try to push it
forward. If the rear tyres turn, the brakes
need to be tightened.
To tighten:
1. Locate the brake adjustment nuts on the
interior side of each of the rear wheels.
2. Turn each adjustment nut 1/4 turn
clockwise, then try again to push the
mower.
3. Continue rotating each nut 1/4 turn and
testing until the mower can no longer be
moved by pushing.
After fi nal adjustment, test the brakes by
driving the mower at normal speed on fl at
ground to be sure the mower stops quickly
when the brake pedal is pressed.
Adjustment nut
REPLACING THE HEADLIGHTS
See fig. 28
Contact an authorised service centre to order
a new headlight.
1. Stop the product on a level surface, and
engage the parking brake.
2. Turn off the product, and remove the start
key.
3. Remove and set aside the hex head
screw and flat washer holding the mower
floor panel in place.
4. Lift floor panel slightly to access the
two hex head screws and flat washers
securing the headlight in place. Remove
screws and washers and set aside.
5. Disconnect the old headlight and discard.
6. Connect the new headlight, and reinstall
and securely tighten the washers and
screws.
7. Lower the floor panel, and reinstall the
washer and screw to secure.
LEVELLING THE CUTTING DECK
See fig. 29 - 30
If your lawn appears unevenly cut after
using the mower, the cutting deck may need
adjusting. Before deciding that levelling
the cutting deck is necessary, make sure
Fig 27 that the tyres are properly infl ated to the
recommended pressure when mowing. Over-
infl ated or under-infl ated tyres can affect the
Hex key
Screws
Washers
Headlight Fig 28
English |
EN
FR
DE
DA
SV
FI
NO
33