Final Checks - Ryobi RM480e Übersetzung Der Originalanleitung

CHECKING THE TYRE AIR PRESSURE
Check the air pressure in all tyres before
use. Improper air pressure affects handling,
steering response, traction, tyre life, level
cutting, and operator comfort. Ensure that
tyres are infl ated to the recommended
pressure (1.6 bar).
NOTE: Measured or adjust air pressure only
when the tyres are cold.
WARNING
Check the tyre pressure carefully while
infl ating. Too much air in the tyre could
cause the tyre to burst, causing serious
personal injury.
CHECKING THE SIDE DISCHARGE CHUTE
SAFETY INTERLOCK SYSTEM
See fig. 9
Before using the product, check that the side
discharge chute is properly closed. The side
discharge chute has an interlock system that
stops the blades if the side discharge chute is
opened while the blades are running.
Stop using the product and have it serviced
by an authorised service center if the blades
do not stop when the side discharge chute is
lifted during use by an obstacle.

FINAL CHECKS

TESTING THE OPERATOR PRESENCE
SAFETY INTERLOCK SYSTEM
See fig. 10
The safety interlock system stops the blades
if the operator leaves the mower while the
blades are running. Test the system before
each use to ensure that it is working correctly.
1. Make sure that the direction control
switch is in neutral (N) position, and the
blade engage knob is down.
2. Insert the start key, and turn the key to the
ON position.
3. Pull up the blade engage knob to activate
the blades.
4. Briefly stand up but do not get off the
mower.
The blades should stop within 5 seconds. If
the blades do not stop, contact an authorised
service centre.
Do not operate the product until the safety
interlock system has been repaired.
Fig 9
EN
FR
DE
DA
SV
FI
NO
Fig 10
English | 19