simu T5EHz Bedienungsanleitung Seite 8

Re-adjustement of end limits
8
8.1 : Re-adjustement of UP end limits (assemblies B and D only)
1
1- Position the motor on the UP end limit previously set in §4.3 with the UP key.
2- Press simultaneously for 5 seconds the UP and DOWN keys, The motor will run for a half a second in one
direction and then in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Validate the new position by pressing 2 seconds the STOP key. The motor will run for a half a second in one
direction and then in the other direction. The new end limits setting is memorized.
8.2 : Re-adjustement of DOWN end limits (assemblies C and D only)
1
1- Position the motor on the DOWN end limit previously set in §4.3 with the DOWN key.
2- Press simultaneously for 5 secondes the UP and DOWN keys, The motor will run for a half a second in one
direction and then in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Validate the new position by pressing 2 seconds the STOP key. The motor will run for a half a second in one
direction and then in the other direction. The new end limits setting is memorized.
- The re-adjustment of end limits is automatic every 56 cycles (during 4 cycles) or after a power supply failure
for the following installation : Up end limit, mounting A and C; Down end limit, mounting A and B.
Cancelling programming
9
9.1
- Switch off the power supply to the motor for 2 seconds.
- Switch on the power supply to the motor for 7 seconds.
- Switch off the power supply to the motor for 2 seconds.
- Switch the power to the motor back on. The
motor will run for 5 seconds in random direction
and is now in the "cancelling" mode.
If you switch off the power to several motors, they will all be in cancelling mode. That is why,
you must "eject" out of this mode all the receivers that are not to be deprogrammed by sending
a command from their individual control transmitter.
9.2- Then, validate the cancelling of the affected motor from the individual control or from a new
transmitter
- Press the "PROG" key of the transmitter more than
7 seconds. Maintain the pressure until the motor
will first run for a half a second in one direction and
then in the other, and a few second later, it will run
again in both direction.
The EHz motor is now as it was originally configured, and no transmitter and no settings is saved in
its memory and is ready for a new programming.
Hereby, SIMU, declares that this equipment "T5EHz" is in compliance with the essential requirements and
other relevant provision of Directive 1999/5/EC. A declaration of Conformity is available at the web address:
www.simu.fr, heading "Normes". Usable in UE,
2
5s
2
5s
3
3
OFF ON
2s
7s
"7s
>>
PROG
4
2s
4
2s
5s
OFF
2s
>>
2s
7s
ON
4 / 4