simu T5EHz Bedienungsanleitung Seite 7

D
1 2
1- Position the motor on the DOWN end limit by using the keys DOWN or UP.
2- To memorize the DOWN end limit position, press simultaneoulsy the keys STOP and UP. The motor will run automatically in the UP direction.
3- When the motor arrives on the UP End limit, press the key STOP.
4- If necessary adjust the position with the keys UP or DOWN.
5- To memorize the UP end limit position, press simultaneoulsy the keys STOP and DOWN. The motor will run automatically
in the DOWN direction.
6- Press 2 seconds the STOP key to validate the setting. The motor will stop, and will run for 1/2 second in one direction,
then in the other direction. Go to §5.
- After these operations, you can program the transmitter used before as a 1st control point. To
do so, see chapter §5.
- If you do not want to keep this transmitter and program it, cut the power supply. When you
will program another transmitter with this motor (eg.: after the shutter installation) refer
directly to chapter §4.1. In this case, when you switch on the power supply, the motor must
rotate for 1/2 second in one direction and in the other. That indicate the end limits are set but
the controls are not programmed. Then go to stage §5 for programming.
Programming the first individual point of control
5
This operation can only be performed from the transmitter that was used for operation 4.1.
- Press the transmitter "PROG" Key for approximately
one second. The motor will run for 1/2 second in
one direction and then in the other. Your transmit-
ter is now programmed to control the EHz
motor in stable mode
Recording and controling intermediate position
6
Recording :
- Position the motor on the
wanted position.
- Press 5 seconds on the "stop"
key. The motor will run for
1/2 second in one direction
and then in the other.
Programming a new (individual, group or main) control point:
7
7.1 : Open the memory of the receiver from the
control transmitter:
- Press the "PROG" key of the transmitter for about 3
seconds. The motor will run for a half a second in
one direction and then in the other.
7.2 : Validate the operation from the new trans-
mitter you want to programm:
- Press the "PROG" key of the transmitter for about 1
second. The motor will run for a half a second in
one direction and then in the other.
- For group controls, repeat operations 7.1 and 7.2 for each receiver in the group.
- For main controls, repeat operations 7.1 and 7.2 for each receiver in the installation.
- To delete an transmitter from the memory of a receiver, perform operations 7.1 with a
programmed transmitter, then perform the operation 7.2 with the transmitter to be
deleted.
3 4
Controling :
- Press on the "stop" key for
0,5s. the motor goes to the
intermediate position.
5s
5 6
!1s >>
PROG
0,5s
"3s >>
PROG
!1s
>>
PROG
2s
3 / 4