Mounting The Bracket - Panasonic WV-CW960 Bedienungsanleitung

WV-CW960_US 05.11.18 11:08 ページ17
(2) Remove the attachment pipe from the upper
base by loosening 4 screws.
* Special screw (mounting screw): Use a hexagon
wrench for the hexagon screw (M6).

3. Mounting the Bracket

(1) Fix the bracket to the installation surface using
appropriate bolts, nuts or the like (not supplied).
(2) Fix the attachment pipe to the bracket.
(3) Thread cables through the bracket. Connect
cables, referring to CONNECTIONS.
Warning: Seal the cables with plastic or rubber
tape to prevent it from being exposed.
(4) Fix the upper base to the attachment pipe.
• Fasten 4 screws (the screws that were
removed in step (2) of "2. Disassembling the
Camera") making sure that "REAR" engraved
on the upper base faces the wall.
• Fill the gap between the bracket and
attachment pipe with waterproof material
such as silicon clay.See instructions of the
bracket for details.
x4
Attachment Pipe
Cables
Upper Base
Warning: Carefully apply the sealing so that
water or moisture cannot get inside. If water
gets inside the camera it could cause a
shock or fire. Also, if moisture gets inside the
camera it could cause the dome to become
foggy.
4. Mounting the camera
(1) Aim the "START" arrow at the bent portion of the
leaf spring.
Bending
(2) Be sure to hook the fall prevention wire into the
bracket.
(3) Fix the camera to the upper base.
• Move the camera up so that its guide pins fit
into the guide holes of the upper base.
• Turn the camera counter-clockwise to the
end, viewed from the bottom.
• Fasten 3 screws (the screws that were
removed in step (1) of "2. Disassembling the
Camera").
Caution: Tighten the three (3) mounting screws
for the upper base.
Recommended torque: Approximately 2.45
N/m {24 kgf cm}
Poorly tightened screws may result in water
leaking into the camera or possible fire.
-17-
Waterproof Material
x4 Screws
Upper Base
Leaf Spring
Fall Prevention
Wire