To Stop The Engine; Maintenance; Maintenance Schedule - Husqvarna 525BX Bedienungsanweisung

7. Pull the starter rope handle quickly with the left hand.
Pull the starter rope handle again and again until the
engine starts.
Note: Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
8. If the engine is cold set the choke control to the open
position.
9. If the engine is cold let the engine operate for 2-3
minutes to become warm before operation.
WARNING: Air is released when the
engine is started and when the product
is set at idle speed. Do not let persons to
come near the product or the blower
pipe.
To operate the product
• Operate the product at usual work hours. Obey local
regulations.
• Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at lowest
position possible to prevent more noise and dust
than necessary.
• Keep the blower nozzle near the ground.
Note: Husqvarna recommends that you use the full
blower nozzle extension.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Maintenance

Clean the external surfaces.
Make sure that the throttle control operates correctly.
Make sure that the start/stop switch operates correctly. Refer to
the start/stop switch on page 5 .
Examine the engine, the fuel tank and the fuel lines for leaks. Examine the fuel
filter for contamination. Replace the fuel filter if it is necessary.
Clean the air filter. Replace the air filter if it is necessary.
Tighten nuts and screws.
Examine the air intake and make sure that it is not blocked.
Examine the starter and the starter rope for damages.
8
• Make a note of the wind direction and operate the
product in the direction of the wind.
• Use applicable garden tools to release material from
the ground.
• In areas with dust, use spray equipment to wet the
area. This decreases the operation time.
• After operation, keep the product in storage
vertically.

To stop the engine

• Put the start/stop switch in the stop position.
Maintenance
To do a check of
CAUTION: Do not stop the product at full
speed.
Daily Weekly
X
X
X
X
X
X
X
1436 - 001 - 09.03.2020
Monthly
X