Operation - Husqvarna 525BX Bedienungsanweisung

To assemble the blower pipe
1. Loosen the clamp screw (A).
B
D
E
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
Fuel
This product has a two-stroke engine.
CAUTION: Incorrect type of fuel can result in
engine damage. Use a mixture of gasoline
and two-stroke oil.
Premixed fuel
• Use Husqvarna premixed alkylate fuel for best
performance and extension of the engine life. This
fuel contains less harmful chemicals compared to
regular fuel, which decreases harmful exhaust
fumes. The quantity of remains after combustion is
lower with this fuel, which keeps the components of
the engine more clean.
To mix fuel
Gasoline
• Use good quality unleaded gasoline with a maximum
of 10% ethanol contents.
CAUTION: Do not use gasoline with an
octane grade less than 90 RON/87 AKI.
Use of a lower octane grade can cause
engine knocking, which causes engine
damages.
6
2. Install the intermediate pipe (B) to the blower pipe
3. Install and tighten the clamp screw (A) .
4. Install the round nozzle (D) or the flat nozzle (E) to
C
A

Operation

Two-stroke oil
•
•
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
(C).
the intermediate pipe.
For best results and performance use Husqvarna
two-stroke oil.
If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
0.40
1436 - 001 - 09.03.2020