Use And Maintenance; Electrical Installation - MO-EL SHARKLITE 712 Gebrauch Und Wartung

EN
1. CAUTION REGARDING THE SECURITY
Before using your appliance, read carefully the instructions contained in this booklet, which
furnish important information regarding installation, use and maintenance safety. The book-
let must be keeped and delivered to the new user in case of cession of the machine. The
Manufacturer reserves the right to vary the features of the product without prior notice. The
technical data are merely indicative.
1. This appliance is intended solely for the use it has been designed for, namely room and
people heating. The Manufacturer is not responsible for any damage that could happen for
improper use.
2. After unpacking make sure that the appliance is complete and shows no signs of visible
damage or tampering.
3. Keep packing materials, which are potential dangers, away from children.
4. The device can be used by children at least 8 years (as well as by persons with reduced
physical, sensory or mental capabilities, or lack of experience or required knowledge)
provided that they are under surveillance, or after they have been instructed relating to
the safe use and have understood the potential dangers. Children should not play with
the appliance. Cleaning and maintenance must be performed by the user and not by
unsupervised children.
5. Before inserting the plug make sure that the voltage is the same as indicated on the
device.
6. Do not use in presence of gas, inflammable or explosive liquids or substances.
7 . Some fundamental rules which apply to all electrical devices must be observed when
using the heater:
• Do not touch the heather with wet hands.
• Do not handle with bare feet.
• Do not pull the electric cord or the device itself to unplug it from the socket; pull
the plug directly.
8. Avoid the use of an extension cord with this product, because the extension cord may
overheat and cause a risk of fire.
9. Do not apply any modification to the product that could compromise the safety.
10. Keep connections dry.
11. If the power supply cord is damaged, avoid to use the appliance. For power cord replac-
ing, please contact the manufacturer or the technical service or a person with similar
qualification, in order to avoid any risk.
12. If the appliance is not used for a long period, disconnect it from the power supply.
13. Always unplug the appliance before doing any maintenance operation.

2. ELECTRICAL INSTALLATION

Installation should always be carried out by a qualified electrician or a competent
person in accordance with the standards HD 384 CENELEC for Europe, or inter-
national IEC 60346-7-708 1988, and the standard AS/NZS 3000 (Australian wiring
rules).
The energy supply must be done through a properly grounded socket. In case of
directly connection to supply line an overvoltage category III bipolar circuit breaker
with contact opening distance of at least 3 mm must be fitted upstream from the
supply line.

USE AND MAINTENANCE

6