Inhaltsverzeichnis
Werbung
en
Cleaning the appliance
1. Pull out the mains plug or switch off the
fuse.
2. Wipe the door seal with clear water only
and then wipe dry thoroughly.
3. Clean the appliance with lukewarm
water and a little washing up liquid.
The rinsing water must not run into
the light. Fig. t/A and B
Note:
Regularly clean the condensation
channel and drainage hole, Fig. r,
so that the condensation can flow out.
Clean the condensation channel with
cotton buds, etc.
The rinsing water must not run through
the drain hole into the evaporation pan.
After cleaning the appliance, re insert
the stopper into the drainage hole for
functional reasons.
Do not use abrasive or acidic cleaning
agents and solvents.
4. After cleaning: reconnect and switch
on the appliance.
Attention!
Never clean the shelves or containers
in the dishwasher. The parts may warp!
36
Cleaning the cool fresh
space
When cleaning the appliance, all drawers
and telescopic rails can be taken out of
the cool fresh" compartment.
Removing the drawers
Pull out the drawers all the way, lift up and
remove. Fig. w
When inserting the drawers, place them
on the telescopic rails and slide in
(drawers lock onto the telescopic rails).
Removing the humidity filter
The humidity filter, Fig. 1/9, above the
humidity drawer can also be removed.
To do this, first remove the humidity
drawer. Then, lift humidity filter and pull
out.
Lift filter cover, Fig. e, remove filter, clean
in luke warm water, allow to dry and
reassemble.
General information for
looking after the surfaces
Clean surfaces with luke warm water and
a little washing up liquid.
After cleaning, rub thoroughly dry.
Werbung
Inhaltsverzeichnis
