Inhaltsverzeichnis
Werbung
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with
a 10 A fuse or higher.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may
be replaced by an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or
to power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
Switching on
the appliance
Fig. 2
Press the On/Off button. Warning signal
is emitted.
To stop the warning signal, press the
Alarm button 3. When the door is opened,
the interior light comes on.
We recommend storing perishable foods
at a temperature not warmer than +4 °C.
The set values for the cold storage
compartment can be changed, see text
on fascia.
Note:
The temperature in the freezer
compartment depends on the
temperature at the bottom of the fridge.
Lower fridge temperatures produce lower
freezer compartment temperatures.
en
21
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
