Stove STP Serie Gebrauchsanweisung Seite 142

an optimal height for the reduction of the emis-
sions and they protect the integrity of the boiler
acting as protective shield between the flame and
the wall of the boiler.
Anytime it is necessary a deeper ash cleaning,
when the thermal cooker is cold it is possible to
remove these sheets. To do this, it is necessary to
remove the hotplate disc or the circles.
Then it is necessary to remove the plate in order
to have more space to do the operation. At this
7.4 GRILL CLEANING
Every time you use the thermal cooker you have
to clean the wood carrying grill before, at least you
have to clean the more rough deposits: the holes
of the grill should not be obstructed. To make this
you can use the poker given together with the
7.5 FUME-CIRCUIT INSPECTION (STP)
In the STP thermal cooker the combustion fumes
are forced to turn completely around the oven.
For this reason, the thermal cookers with oven
are endowed with an inspection door to clean the
fume-circuit. The cleaning must be done at least
Picture 43 - Fume-circuit inspection.
7.6 ASH BOX
Every time you use the thermal cooker you have to
check the ash box located under the combustion
chamber. When the box is full, you have to empty
it. If you do not empty it, the ash accumulates itself
point, remove the sheets starting from the sides of
the combustion chamber and last the ones placed
in the rear part, unhooking them from the pin and
unthreading them up.
To reassembly the sheets it is necessary to do the
reversal operation, paying attention to insert them
in the correct position and in the correct order,
placing in the first time the base and then hooking
them to the pin.
thermal cooker. If the grill is not well cleaned, the
flame could not be well feed and so you could ex-
perience an irregular combustion. If the grill is be-
ing removed, it must be placed in its housing with
the flat part turned upwards.
every six months of normal use, like for the chim-
ney sweeping: according to use, you could have
to make the cleaning more often. The inspection
door is located under the oven door opening the
apposite wing.
and makes the cleaning more difficult. In case of
excessive cinders the flame could not be well fed
and you could experience an irregular combustion.
140
1