Cleaning The Accessories - SOLIS GRIND & INFUSE COMPACT Bedienungsanleitung

Let the tablet dissolve and act for at least 15 minutes.
●
Press the button again and wait for one minute. Repeat this process five
●
times.
After that, screw out the portafilter. Remove the filter insert and the white coin
●
and rinse the portafilter and the filter insert thoroughly under running water.
Dry both parts.
Switch the appliance off with the On/Off button, disconnect the power plug and
●
clean the brewing head with a soft, moist towel or sponge to remove all cleaning
tablet residues.
GB
Proceed in the same way for all filter inserts that you have used.
●
CLEANING THE BREWING HEAD AND THE BREWING GROUP
■
Coffee grease and other contaminations can also collect on the brewing head
●
and the brewing group. Remove them with a toothpick or a soft, moist sponge or
towel when the appliance is disconnected and switched off, or let hot water run
through while the appliance is switched on and the portafilter is not screwed in.
C LEA N I NG TH E A CCES SORIES
■
Clean the milk jug after every use in hot dish water.
●
Regularly clean the lid of the bean container with warm dish water and subse-
●
quently rinse it with clear water. Then, dry it carefully and place it back on the
bean container.
C LEA N I NG TH E STE AMIN G N OZ Z LE O F T H E S T E AM / H OT
■
WAT ER W A ND
CAUTION: The appliance has to be switched off, unplugged and cooled down be-
fore the steam / hot water wand with the steaming nozzle is cleaned!
Unscrew the steaming nozzle from the steam / hot water wand. Rinse the steam-
●
ing nozzle carefully in warm water and then re-rinse it with clear water.
Should the nozzle be blocked, insert the big needle of the cleaning tool into the
●
opening of the nozzle. If the nozzle still is clogged, first place the nozzle in a glass
of hot water, then use the needle again to remove the blockage.
162
Screw the nozzle back onto the steam/hot water wand.
●
After each cleaning cycle and before starting to use the appliance again, you
●
should activate the steam function for a couple of seconds to clean the nozzle
of any residues.
C L EA N IN G T H E C H A SS I S , TH E C U P SH E LF, TH E B EA N
■
C O N TA I NE R AN D THE W A TE R TA N K
Clean the chassis, the cup shelf, the empty bean container and the water tank
●
with a soft, slightly moist towel and dry all parts with a dry towel.
C L EA N IN G T H E D R I P TR A Y W I TH D R I P GR I D
■
Remove, empty and clean the drip tray with the drip grid at regular intervals but
●
every time it is full and the red float gauge is visible between the drip grid.
Remove the drip grid and pull the drip tray out to the front. Hand wash the
●
drip tray and the drip grid with mild detergent and warm water. Do not use any
aggressive cleaning agents or scouring sponges. Rinse the tray and the grid with
clear water and carefully dry both parts.
CAUTION:
Drip tray and drip grid are not
dishwasher safe.
Reinstall the drip tray
●
and place the grid back
on the drip tray.
Tip: The black cover behind the grid
can be removed for cleaning.
C L EA N IN G T H E G R I N D E R
■
We recommend regularly cleaning the grinder with GRINDZ™ (art. no. 993.08) to
●
clean it from coffee grease and oil. This is to preserve the quality of the ground
coffee.
GB
163