Care And Cleaning - SOLIS BarVista Bedienungsanleitung

CARE AND CLEANING

Cleaning the steam wand and frothing attachment
• The Steam Wand and Frothing Attachment should
always be cleaned after frothing milk.
• Remove the Frothing Attachment and rinse in warm
tap water. Ensure the two fine steam holes on either
end of the Frothing Attachment are clear. Use the pin
on the Cleaning Tool to unblock these holes.
• Wipe the Steam Wand with a damp cloth, then with the
Steam Wand directed back into the drip tray, briefly set
the Selector Control to the 'Steam' position and press
the Hot Water button. This will clear any remaining
milk from inside the Steam Wand.
• Ensure the Selector Control is in the 'Standby' position.
Press the 'ON/OFF' button to OFF, unplug the power
cord and allow the machine to cool.
• If the Steam Wand remains blocked, use the pin on the
Cleaning Tool to clear the opening.
• If the Steam Wand continues to be blocked, the tip of
the Steam Wand can be removed by using the spanner
in the middle of the Cleaning Tool.
40
• Soak the tip in hot water before using the pin on the
Cleaning Tool to unblock. Replace the tip back onto the
Steam Wand and secure with the Cleaning Tool.