Operating A Drip Lubricator; Changing Lubricant - struers LaboForce-3 Gebrauchsanweisung

Operating a Drip Lubricator

(Accessory)

Changing Lubricant

Drip Lubricant
(Accessory)
LaboDoser Dosing Unit
(Accessory)
LaboForce-3
Instruction Manual
 Position the dosing nozzle in the correct position over the
preparation disc.
 Open the valve and adjust the lubricant dosing level.
 After the preparation step has been completed close the valve
to stop lubricant dosing.
 Remove the drip lubricator from LaboForce-3
 Hold the lubricant bottle firmly and remove the top lid.
 Pour out the lubricant, and fill the bottle with a mild soap
solution.
 Open the valve and clean the tube.
 Exchange the soap water with clean water and repeat the
above procedure.
 Empty the lubricator.
 Put the lubricator back on LaboForce-3 and tighten the finger
screw.
 Refill with lubricant and mount the top lid.
Follow the Instructions for Use that are supplied with the Dosing
Unit.
7