Installation; Installation Conditions; Compressor Assembly - EKOM DK50-10S/M Benutzerhandbuch

INSTALLATION

INSTALLATION
Risk of incorrect installation.
Only a qualified professional can install the compressor and place it into
operation for the first time. His obligation is to train the operating personnel on
the use and maintenance of the device. He shall confirm installation and
training of operators by an entry into the installation record (see Annex).

8. INSTALLATION CONDITIONS


The compressor may only be installed and operated in dry, well-ventilated and dust-free
rooms with conditions stated in Technical data.
Risk of damage to the device.
Do not operate the device in outdoor environment or in humid or wet rooms.
Explosion risk.
Do not install the device in any rooms, in which explosive gases, dusts or
flammable liquids may be present.

The compressor must be installed in such a way, that it is accessible at all times for
operation and maintenance and label on the device is accessible.

The compressor must stand on a flat, sufficiently stable base (be aware of the compressor
weight, see chap. Technical data).

Ensure the air delivered by the compressor meets the requirements for its intended use
before installing the compressor. Refer to the technical data of the product for this purpose.
The supplier of the final product must classify and evaluate compliance with the intended
application.

Any other use or use above this framework is not considered to be proper use. The
manufacturer is not responsible for damages that arise from such use. The operator/user
assumes all risk.
Cabinet-mounted compressors can only be operated in areas with continuous
air circulation and away from any sources of heat or direct exposure to
sunlight.
Risk of damage to the device.
The equipment must be located at least 100 mm from a wall in order to ensure
proper cooling air circulation. Failure to comply with such spacing may cause
damage to the compressor and cabinet!

9. COMPRESSOR ASSEMBLY


Unpack the compressor from the packaging.
9.1. Manipulation and fixation removal

Put the compressor at the place of operation

Use a hex key to rotate the stabilizer screw (X) down to the stop to the position
air pump will reach the operating position (Fig. 3).
01/2020 15
- the
NP-DK50-10SM-4_01-2020