Safety Warnings - Megger Scits100 Gebrauchsanleitung

# The Test Set MUST be connected to earth (ground).
The Test Set is capable of dangerous outputs, follow all appropriate safety precautions.
#
# Keep the output terminals and the test leads clean and in good order.
# Use test leads rated at 100 A or greater.
# Before switching the mains power supply on, ensure that both output controls are set fully
anticlockwise and the 'Set/Test' switch is at '0'.
# Replacement fuses must be of the correct type and rating.
Refer also to page 10 for further explanations and other precautions.
The warnings and precautions must be read and understood before the Test Set is used. They must
be observed during use.
This instrument must only be used by suitably trained and competent persons.
2

SAFETY WARNINGS

NOTE
Symbols used on the instrument
Caution: Refer to accompanying notes.
Equipment complies with relevant EU Directives.