Disposal Of The Packaging; Charging The Power Bank - Silvercrest SSP 2600 A1 Bedienungsanleitung

Disposal of the packaging

The packaging protects the device from
damage during transport . The packaging
materials have been selected for their en-
vironmental friendliness and ease of dis-
posal, and are therefore recyclable .
Returning the packaging to the material cycle conserves
raw materials and reduces the amount of waste that
is generated . Dispose of packaging materials that are
no longer needed in accordance with applicable local
regulations .

Charging the power bank

Before using the power bank, the integrated battery
must be fully charged .
CAUTION
► The power bank must never be charged and used
for charging an external device at the same time .
► Only use power supplies with an output voltage
of 5 V and an output current of at least 1 A or
a USB 3 .0 port on your computer to charge the
power bank . You can recognise the USB 3 .0
port due to the blue marking .
► When charging via a USB port, ensure that at
least one further USB port remains free . This also
applies when using USB 3 .0 ports .
► Not all USB 2 .0 ports deliver sufficient power to
charge the power Bank . If this is the case, use an
external power supply or a USB 3 .0 port .
♦ Disconnect the selfie stick with the integrated power
bank from the telescopic shaft 5, if necessary,
by rotating the selfie stick anticlockwise until it be-
comes loose . You can now pull off the selfie stick .
♦ Connect the USB plug of the charging cable e to a
turned-on PC or a USB power supply (not included) .
♦ Connect the micro-USB plug of the charging cable
e to the micro-USB port 0 on the power bank . A
rough estimate of the charge level is shown during
charging by means of the charge level LEDs 9 .
SSP 2600 A1
GB │ IE
│
25 ■