Using The Selfie Stick; Connecting The Selfie Stick And Smartphone - Silvercrest SSP 2600 A1 Bedienungsanleitung

♦ During the charging process, the current charge
level of the power bank is shown via the charge
level LEDs 9 (see table in section "Checking the
charge level") .
♦ To stop charging, disconnect the charging cable e
from the mobile device and the power bank .
The charging status LEDs 9 go off after about
30 seconds .

Using the selfie stick

Before you use the selfie stick, you must first pair it with
your smartphone or compact camera via Bluetooth
This pairing creates a link between your smartphone or
your compact camera and the selfie stick .
NOTE
► Make sure that the battery of the power bank is
charged; otherwise the selfie stick will not work .
If necessary, charge the power bank battery
before using the selfie stick . Refer also to section
"Charging the power bank" .
Connecting the selfie stick and smart-
phone/compact camera via Bluetooth
♦ Turn on your smartphone or compact camera and
activate the Bluetooth
♦ Press and hold the On/Off button 8 for about
2 seconds to activate the Bluetooth
The Bluetooth
7 seconds and then flashes for one minute . The
charging status LEDs 9 light up and then go off
after about 30 seconds .
Set the smartphone so that it scans for Bluetooth
♦
devices . You will find a detailed description of
how to do this in the operating instructions for your
smartphone .
Select SSP 2600 A1 from the list of found devices
♦
on your smartphone to pair the two devices . The
Bluetooth
is successful .
SSP 2600 A1
®
® LED 7 lights up for approx .
® LED 7 stops flashing when pairing
function .
®
GB │ IE
® .
®
function .
®
27 ■
│