Disposal Of The Packaging; Charging The Power Bank - Silvercrest SSP 2600 A1 Bedienungsanleitung

Disposal of the packaging

The packaging protects the device from
damage during transport. The packaging
materials have been selected for their en-
vironmental friendliness and ease of dis-
posal, and are therefore recyclable.
Returning the packaging to the material cycle conserves
raw materials and reduces the amount of waste that
is generated. Dispose of packaging materials that are
no longer needed in accordance with applicable local
regulations.

Charging the power bank

Before using the power bank, the integrated battery
must be fully charged.
CAUTION
► The power bank must never be charged and used
for charging an external device at the same time.
► Only use power supplies with an output voltage
of 5 V and an output current of at least 1 A or
a USB 3.0 port on your computer to charge the
power bank. You can recognise the USB 3.0
port due to the blue marking.
► When charging via a USB port, ensure that at
least one further USB port remains free. This also
applies when using USB 3.0 ports.
► Not all USB 2.0 ports deliver sufficient power to
charge the power Bank. If this is the case, use an
external power supply or a USB 3.0 port.
♦ Disconnect the selfie stick with the integrated power
bank from the telescopic shaft
by rotating the selfie stick anticlockwise until it be-
comes loose. You can now pull off the selfie stick.
♦ Connect the USB plug of the charging cable
turned-on PC or a USB power supply (not included).
♦ Connect the micro-USB plug of the charging cable
to the micro-USB port
rough estimate of the charge level is shown during
charging by means of the charge level LEDs
SSP 2600 A1
, if necessary,
on the power bank. A
GB │ MT
│
to a
.
43 ■